This test is done in the hospital. You will lie on an x-ray table. The health care provider will clean and shave the area of the body (usually near the groin) where a needle will be placed into the artery. A local numbing medicine will be put on the area before inserting the needle. Once the needle is in the proper position, a thin guide wire passes through it. The needle is taken out, and a long, narrow, flexible tube called a catheter is put in its place. The catheter runs over the wire and pushed up into the main blood vessels of the pelvis to the aorta (the main blood vessel running down from the heart to the lower body). During the procedure, a fluoroscope sends special x-ray images of the body to a TV monitor. This helps the radiologist guide the catheter into the right position. Once in place, the dye is sent through the catheter into the renal artery. X-ray images are taken as the dye moves through the blood vessels. Saline (sterile salt water) contain a blood thinner may also be sent thru the catheter to keep the blood in the area from clotting. After the x-rays are taken, the catheter is taken out. Pressure is immediately applied to the area of the needle stick for 10 to 15 minutes or more to stop the bleeding. After that time, the area is checked and a bandage is applied. The leg should be kept straight for 6 hours after the procedure. Digital Subtraction Angiography (DSI) uses a computer to "subtract" out the bones and tissues in the region so that only the blood vessels filled with the dye can be seen. |